5. Replace the lower blade by securing it with the
three fasteners using the 9/64” Allen wrench pro-
vided.
6. Replace the upper blade by inserting the cap
screws into the threaded holes and using them as
handles to raise the blade up into the machine so
that it engages the knuckle key. Remove the left
screw and swing the blade holder over the blade
and insert the screw into the holder. Snug the screw
with the 3/16” Allen wrench. DO NOT TIGHTEN.
Remove the screw from the right side of the blade
and swing the right blade holder over the blade.
Insert the screw into the hole and tighten with the
3/16” Allen wrench provided. Tighten the left side
blade holder. Make sure upper blade is centered
with the lower blade.
7. Whenever a blade or both blades are replaced
follow the adjustment procedure.
BLADE ADJUSTMENT
1. Tip the machine onto its backside and loosen
the two large screws on the bottom of the ma-
chine with the 3/16” Allen wrench (see Specifica-
tion Photo 4).
2. Tip the machine back onto its feet and loosen
the two tension screws in the bottom of the lower
blade holder with the 3/16” Allen wrench. Push the
lower blade holder towards the center of the ma-
chine.
3. Lower the upper blade so that only the leading
edge of the upper blade covers the lower blade.
Caution: ensure the upper blade does not hit
the top of the lower blade as this will damage
the upper blade.
4. Tighten the tension screw in the lower blade
holder so the lower blade comes in contact with
the upper blade. Raise the upper blade and slowly
lower it down again to ensure the upper blade does
not come down on top of the lower blade.
5. Lower the upper blade all the way down and
tighten the left tension screw on the lower blade
holder until the lower blade is snug against the up-
per blade.
6. Raise the upper blade and slowly lower it back
down. There should be a smooth shearing action
like a pair of scissors. If not, repeat steps 3 thru 5
again until you achieve a smooth shearing action.
7. Tip the machine onto its backside and tighten
the two screws securing the lower blade holder
with the 3/16” Allen wrench.
8. Return the machine to an upright position and
recheck the shearing action of the blades.
9. Return the machine to service by installing the
safety guard, air supply and power.
GROUND LOCATION
This protective Earth ground la-
bel is located inside the hous-
ing beside the ground wire. This
wire is connected to the Power
Supply Cable and is wired back
through the Mains supply to
ground.
CAUTION LABEL
Refer to the operating instruc-
tions before using this unit. High
voltage is inside this unit and
power must be disconnected
before servicing.
ON/OFF LABEL
This is the ON/OFF switch.
Press I for on and press O for
off. This switch is also the anti-
start switch. In case of power
outage, this switch must be reset
for the unit to operate.
CE MARKING
Indicates compliance with all ap-
plicable EU directives.
