www.equip-info.net
2.0 Getting started
2.1 Inserting the battery
Open the battery cover and insert two AAA batteries.
Be sure that the polarity of the batteries is set properly.
Do not charge, heat, open, or short-circuit the batteries.
Do not leave dead or exhausted battery in the presenter.
If you do not intend to use this unit for a long period of time, it is advisable to remove the batteries.
If the wireless presenter does not function correctly or if the operating range becomes reduced,
try to replace the battery with new ones.
Do not use different type of batteries together, or mix old and new batteries.
2.2 Connecting the RF receiver
Connect the receiver to your notebook computer by plugging it into an available USB port. If all your USB
ports are occupied, you can also plug it into a connected USB hub.
Do as follows, depending on your operating system:
Windows® 98 SE/Me
The system prompts you to insert the operating system CD-ROM. Follow the instructions on the screen
to install the required drivers.
Windows® 2000/XP
The operating system identifies the receiver as a USB Human Interface Device and begins installation
automatically. Follow the instructions or messages on the screen to complete the installation.
Mac® OS
The receiver is automatically detected and enabled.
2.3 Activate the laser
Press and hold both Fn and On/Off key on the right side for two seconds to activate the laser.(the mode
indicator flashes) If you have several RF devices within range and working at the same channel, the
presenter is jammed evidently, you need to change RF ID for better communication quality.
Please do as follows:
1.Press the ID link button on the receiver and the LED lights up steady. This means the receiver is ready
for linking.
2. Press the Fn and Link keys on the Presenter simultaneously for more than three seconds. The LED on
the receiver begins blinking to confirm a successful link.
Note:
Whenever you change the batteries, we recommend you to implement the procedure given above.
Now, your 3-in-1 Wireless Presenter is ready to go.
Manual_
Page 5