4.2 DMX Controller
By using a universal DMX controller to control the units, you will need to set
a DMX address from 1 to 512 so that the units can receive a DMX signal.
Press the
MENU
button until
is showing on the display. Press the
ENTER
button and the display will blink. Use the
DOWN
and
UP
buttons to
change the DMX-512 address. Once the address has been selected, press
the
ENTER
button to confirm. To go back to the functions without any
changes press the
MENU
button again. Press and hold the
MENU
button
one second or wait for one minute to go back to the main menu.
Please refer to the below diagram to address your first 4 units
：
Channel
mode
Unit 1
Address
Unit 2
Address
Unit 3
Address
Unit 4
Address
1 channel
1
2
3
4
7 channel
1
8
15
22
4.3 DMX 512 Configuration
1 CHANNEL MODE:
Channel
Value
Function
1
000-007
Blackout
008-067
Show 1
068-127
Show 2
128-187
Show 3
188-255
Random shows
7 CHANNEL MODE:
4.Troubleshooting
Following are a few common problems that may occur during
operation and some suggestions for easy troubleshooting:
A. The unit does not work, no light and the fan does not work
1.
Check the connection of the power and the main fuse.
B. Not responding to DMX controller
1.
DMX LED should be on. If not, check DMX cables to see if linked
correctly.
2.
If the DMX address is showing but no response to the controller, check
the address settings and DMX polarity.
3.
Try another DMX controller.
C. No response to the sound
1.
Make sure the unit is not receiving a DMX signal.
Channel
Value
Function
1
0-255
Pan
2
0-255
Tilt
3
0-255
PAN/TILT Speed
(slow-fast)
4
0-255
Dimmer
5
0-255
Strobe(slow-fast)
6
0-255
NO FUNCTION
7
0-010
NO FUNCTION
011-255
Sound
