start or run.
●
Motor (bad bearings or locked
rotor).
◇
Replace motor.
Motor trips out on in
terminal thermal overload
protector.
●
Start relay not dropping out.
●
Improper voltage.
●
Seal faces binding.
●
Motor shaft binding.
●
Motor windings shorted.
●
Glass or foreign items in pump.
◇
Replace start relay.
◇
Check voltage.
◇
Repair or replace.
◇
Repair or replace.
◇
Repair motor.
◇
Clean and clear area.
Repeated dishwasher cycles
●
Circuit board (contacts open or
burnt)
●
Motor (inoperative, check
resistances).
◇
Replace circuit board.
◇
Replace timer.
Dishwasher does not
advance automatically.
●
Damaged circuit board.
●
Check circuit for power ,check if
the wire misconnected.
●
Have wire cut off
◇
Replace circuit board.
◇
Reconnected wire and circuit
board .
◇
Repair.
Dishwasher will not fill with
water.
●
Water supply turns off.
●
Defective inlet valve.
●
Check valve screen for
obstructions.
●
Defective float switch.
●
Damaged circuit board.
●
Wiring (broken or burnt).
◇
Turn water supply on.
◇
Replace inlet valve.
◇
Disassemble and clean screen.
◇
Replace switch.
◇
Replace circuit board .
◇
Repair or replace.
Incomplete water fill.
●
Low water pressure.
●
Clogged water inlet valve screen.
●
Heavy water supply usage
elsewhere in home.
●
Kinked or restricted fill hose, water
inlet valve to fill tunnel.
◇
Minimum water pressure of
15P.S.I
◇
Clean water inlet valve screen.
◇
Use dishwasher when water
usage is at a minimum.
◇
Correct as needed.
Too much water fill.
●
Water inlet fill valve defective.
●
Damaged circuit board (open or
burnt).
●
Float arm binding or out of
adjustment.
◇
Replace water inlet fill valve.
◇
Replace circuit board.
◇
Repair, adjust or replace.
Dishwasher will not pump
out.
●
Drain pump is restricted.
●
Damaged impeller.
●
Wiring or terminal (contacts open
or burnt).
◇
Clear restrictions.
◇
Replace drain pump.
◇
Replace circuit board.
Water siphons out.
●
Drain hose loop to low.
●
Drain line connected to a floor
drain not vented.
◇
Move to proper height.
◇
Install vent air gap at counter
top.
Water leaks.
●
Spray arm not rotating or split.
◇
Check for proper rotation or
replace spray arm.
11
