17
6) Wash Timer (50819)
Replacement Procedure:
▪
Unplug the unit.
▪
Remove the top panel (Two screws behind and slide back)
▪
Pull out the soap dispenser, plastic washer knob and dryer knob.
▪
Remove the control panel. (3 Screws)
▪
Unfix the screw that holds the timer cam to the timer shaft and pull out the timer cam.
▪
Unfix the two screws that hold the timer and take out the timer.
▪
Pull out all the housing of wires from the terminals of the timer and replace the same.
▪
Fix all the parts back by following the reverse procedure.
e
Please Note:
1) The timer is to be installed at an angle as shown in the figure above.
2) The timer cam should be installed making sure that it is holding the cam
follower properly.
3) The washer knob has 2 grooves (one wider than the other) and there are
two projections on the timer cam (one thicker than the other) and so
matching the wider groove to the thicker projection is very important or
else there will be mismatch of cycles.
Timer Cam
Cam follower
Timer Angle
