As long as the diode is on, the fan will not start counting down the stop delay after which the fan is switched off. It will take place only after the humidity level
in the room drops and the green diode goes off.
Cord switch (part name suffix 'W').
Connect the fan with the cord switch as shown in the electrical wiring diagram, see Fig. 5.
The fan is switched on and off by subsequent instances of pulling the cord switch.
Movement (part index letter 'M').
Connect the air exhaust fan with the microwave motion sensor and timer as shown in the electrical wiring diagram, see Fig. 5.
The fan starts when the motion sensor detects someone in the room. The fan is equipped with stop delay which is counted from the moment of the last detection of
motion in the room. The stop delay time and the sensitivity of the sensor can be set with a potentiometer knob on the electronic module. The adjustment range of the
delay is 3 -30 min. Minimum delay time value and the sensor sensitivity is achieved by turning the potentiometer knob counter-clockwise. The stop delay time is
adjusted in infinite increments. The sensing zone of the motion sensor is shown in Fig. 7.
NOTE: The microwave sensor has the widest range when used with a front panel made entirely of plastic. The controller does not work properly with panels
containing metal elements, and when used with glass panels its sensitivity decreases by about 20%.
INSTALLATION
The fan shall only be installed, connected to electrical mains and commissioned
for use by qualified personnel in accordance with applicable laws!
Installation process
•
Precise where the fan will be installed.
•
Prepare the power cord. Use
H03VV-F (OMY) 2x1,5 mm² or H03VV-F (OMY) 3x1,5 mm²), a maximum outside diameter of 7.5 mm, depending on the optional
accessories provided.
NOTE: Before starting work, make sure that the power cord is not live.
•
Measure and drill the holes for the fan and for the ø6 mm wall bolt plugs included with the product.
•
Remove the front clip-on frame (
2
) of the fan.
•
Remove the controller’s cover (
1
) which is secured with the screws (
6
).
14
EN
Содержание LMKW 100
Страница 19: ...Rys 1 Fig 1 2 3 4 6 1 7 8 5 19...
Страница 20: ...L N N L L N N L T L N N L Rys 4 Fig 4 L N T N L Rys 2 Fig 2 Rys 3 Fig 3 Rys 5 Fig 5 20...
Страница 23: ...23...
