Equalizer HP1000D, Инструкция оператора

Страница: 11 / 24

HYDRAULIC SEALED HAND PUMPS
OPERATOR INSTRUCTION MANUAL
PAGE 9
6.2 HP350D, HP550D & HP1000D
The HP350D, HP550D and HP1000D pumps have been designed for use with Equalizer maxi kit
systems, however the HP350D can be used in any situation where 2 separate hydraulic systems
require to be pressurised and controlled independently by the same operator.
WARNING:
Never attempt to pressurise the pump when the gauge is not connected or
the pump is not connected to a system!
DANGER:
Always check the hydraulic system in which the pump is to be used is rated
for 10,000 psi (700 bar). Over pressurising a hydraulic system will result in
component failure and personal injury!
2.
Ensure the hydraulic systems you
wish to pressurise have been bled
and are free from air and leaks.
Connect the pump into the systems
using the screw connectors supplied
with the pump, push the male and
female connectors together fully and
rotate the locking rings clockwise
until fully tight.
WARNING:
Never disconnect the pump
or other components when
the system is pressurised
MALE AND FEMALE
CONNECTORS
LOCKING
RING
1.
Prior to using the pump the hydraulic
gauges must be fitted.
push the male connector on the gauges
and female connector on the gauge
adaptors together fully and rotate the
locking ring counterclockwise until fully
tight.
LOCKING
RING