EQUIPMENT SAFETY SYSTEMS
75 Naxos Way, Keysborough 3173 Victoria Australia
P: +61 3 8770 6555 E: [email protected]
Skyjack SJIII DC Scissor
Plug and Play
Installation Manual
REV 1.2
07/10/2020
Model6253 OverWatch
™
Installation Manual
Document # DO001246
|
11 of 19
|
Post Installation Configuration
Overview
After the OverWatch™ has been installed it must be configured with the parameters to suit the machine. Follow
the instructions below to configure the OverWatch™.
Minimum system requirements
Any smart phone, tablet or laptop that meets the following requirements:
•
The device can connect to a Wi-Fi access point
•
The device has an up to date web browser installed (2019 onwards). Firefox or Chrome are
recommended.
Wi-Fi Connection & Web Page Access
To enable the Wi-Fi connection on the OverWatch™ to complete the configuration follow the steps below.
1.
Power down the platform control box with the ESTOP
2.
Wait 10 seconds
3.
Power up the platform control box with the ESTOP
4.
While standing in the operator position, switch on the OverWatch™
5.
As the welcome chime starts to play, cover the sensor. The LED will flash white then black to acknowledge.
6.
Remove your hand from the sensor. The LED will flash white then black to acknowledge.
7.
After covering then uncovering the sensor this way 2 more times, "Wi-Fi On" will be announced.
8.
On your Wi-Fi enabled device (laptop, tablet, smartphone, etc), show the available wireless networks
9.
Select the wireless network (starts with “overwatch”) to connect to the OverWatch™
10.
When prompted, enter the password “12345678”
11.
Open your preferred web browser (Chrome, Firefox, Safari, Edge)
12.
Enter the following into the address bar
to open the OverWatch™ main page