-17-
COMMISSIONING
Make sure that the voltage on
the rating plate corresponds to
the mains voltage.
THE MAINS POWER
L I N E T H AT T H E
REFRIGERATED CABINET WILL BE
CONNECTED TO MUST BE PROTECTED
BY A HIGH SENSITIVITY CIRCUIT
BREAKER (In=16 A, Id=30 mA) AND
CONNECTED TO THE MAINS EARTHING
SYSTEM.
Follow the manufacturer’s instructions to install
the unit, using qualified personnel and complying
with the electrical regulations for the specific
country.
Incorrect installation may cause injury and damage; the manufacturer is not liable for this.
The manufacturer disclaims all responsability for any damage to people or
things due to incorrect
observance of this rule.
The earthing is necessary and mandatory for the appliance to work properly.
For the connection, never use reductions, extension cords, adapters or multiple sockets.
The connection must therefore be made DIRECTLY to the mains power supply.
The cable should be fully extended and located where it is unilikely to be struck, caught or stepped on,
away from water and the other liquids and heat sources and must not be damaged.
In case of breakage of the power cable of the cabinet, it must be replaced by the manufacturer or by
instruction it change of it.
The plug must still be accessible even after installing the unit.
FINNED CONDENSER CLEANING
Periodically check and remove from the
finned
condenser unit (if present)
the impurity (dust and
deposit) which remain among the fins of the condenser,
obstructing a good circulation of the air
.
A dirty condenser
reduces the performance of the equipment, increasing the
energy consumption.
Cleaning should be carried out with a soft brush or preferably
with a vacuum cleaner.
For a good preservation of the cabinet’s body
a periodical cleaning is necessary
.
EXTERNAL BODY
: When necessary, the external body should be cleaned with a cloth and a neutral
soap and water solution.
STAINLESS STEEL SURFACES
: wash with warm water and mild detergent, rinse well and dry with
soft cloth. Avoid scouring pads etc. which will spoil the finish of the stainless steel.
SURFACES IN PLASTIC MATERIAL
: wash with warm water and mild detergent, rinse well and
dry with soft cloth; under no circumstances should alcohol, methylated spirits or solvents be used.
GLASS SURFACES
: only use products specifically designed for glass cleaning; it is not advisable to
use ordinary water which can leave a film of calcium on the surface of the glass.
