Modello - Modèle - Model
Modell - Modelo
EXTRA SLIM COOL EMOTION
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
PAGE
18/52
N° DOC
UM000300
11. PUTTING INTO OPERATION
If the cabinet has been sharply tilted while being sited or for mounting of accessories, it must
be left to stand for at least three hours before being started to allow the lubricating oil to settle
in the compressor.
Failure to do so can cause total destruction of the compressor refrigerating system.
Check that the voltage on the identification plate is the same as that of
the network.
THE ELECTRICAL SUPPLY LINE TO WHICH THE
REFRIGERATOR WILL HAVE TO BE CONNECTED IS TO
BE PROTECTED BY A VERY SENSITIVE DIFFERENTIAL
SWITCH (Rc=16A,Dc=30mA); IT IS ALSO TO BE LINKED
TO THE GENERAL EARTHING PLANT.
Earthing is necessary and compulsory by law.
Absolutely never use reduction units, patch cords, adapters or multiple
socket outlets to connect the counter.
DIRECTLY connect the equipment to the mains.
The cable should be fully extended and located where it is unilikely to be struck, caught
or stepped on, away from water and the other liquids and heat sources and must not
be damaged.
In case of breakage of the power cable of the cabinet, it must be replaced by the
manufacturer or by instruction it change of it.
Follow the manufacturer’s instructions to install the unit, using qualified personnel and complying with the electrical
regulations for the specific country.
Incorrect installation may cause injury and damage; the manufacturer is not liable for this.
The manufacturer disclaims all responsability for any damage to people or things due to incorrect
observance of this rule.
12. ENERGY SAVING TIPS
• Install the appliance in a dry, well-ventilated room away from heat sources (radiator, cooking surface
and so on) and in a position out of direct sunlight.
•
Follow the installation instructions to ensure adequate ventilation. Insufficient ventilation to the back of
the appliance causes an increase in energy consumption and reduces cooling efficiency.
• The internal temperature of the appliance depends on the room temperature, how often the doors are
opened and where the appliance is placed. These factors have to be taken into account when setting the
thermostat. Only open the doors when strictly necessary.
• Let hot food and drink cool down before placing them in the appliance.
•
The positioning of the shelves in the fridge has no effect on energy efficiency.
•
The fridge compartment light system uses a LED light, which at the same time ensures more efficient
lighting and reduced energy consumption.
13. PROLONGED SWITCH OFF
When the unit is kept unused for a long time, please take note of the following procedures:
• Unplug the unit;
• Clean and dry the tank well;
• Leave the cover slightly open to avoid formation of bad odours;
• Cover the unit with a curtain, place it in a dry room and sheltered from the atmospheric agents.
14. DOOR OPENING
Warning! MAXIMUM ANGLE OF DOOR OPENING = 100°
For correct working of the torsion bar and to avoid any break of the door or of the
hinge do not exceed the maximum angle of door opening i.e. 100°.
MAX
100°
