50
Chapter 3 Advanced Usage
Release condition of receive buffer BUSY
•
Releases when the remaining receive buffer capacity becomes 256 bytes (initial setting)
•
Releases when the remaining receive buffer capacity becomes 138 bytes
Select paper out detector enabled for paper out signal output
•
Roll paper out detector (initial settings)
•
Disabled
Error signal settings
•
Enabled (initial setting)
•
Disabled
Pre-feed before next print
•
Disabled (initial setting)
•
Enabled
Roll paper near-end detection
•
Disabled (initial setting)
•
Enabled
Paper width
•
80mm (initial setting)
•
58mm
The USB power-saving function is valid only when the USB interface communication condition is
set to the vendor-defined class and the system configuration is set so that the USB driver can
support the USB power-saving function.
This function is enabled only when Receive buffer capacity is set to 4KB.
•
When using this function, the top margin is approximately 10.5 mm.
•
This setting becomes invalid if you change the "Amount of top margin by backfeed" setting from
the initial setting (9.5mm (no backfeed)).
