Epson TM-J7200 series, Техническое справочное руководство

Страница: 43 / 112

43
Chapter 3 Advanced Usage
3
Setup methods
When you use "Acquiring the IP Address" for Auto (DHCP), you do not need to set the IP address. When you
set the IP Address manually, follow one of the methods below.
There are three methods for set up.
Method 1: Setup using TM-J7200 TM-J7700 Utility
This method involves installation of the TM-J7200 TM-J7700 Utility to the computer for setup.
Setup is easiest when performed using a USB connection. Setup from an existing computer connected to the
network is also available.
Download TM-J7200 TM-J7700 Utility from the Epson website.
Method 2: Setup using EpsonNet Config (Web version)
This method involves opening the Web application equipped in the printer from a Web browser to perform set-
tings.
Because you specify the printer's IP address to open it, you need to set your computer to the same network seg-
ment as the printer.
Method 3: Setup using arp/ping commands
This method involves setting the printer's IP address in the setting computer's arp/ping commands, then using
the setting tool to change the other settings.
The setting computer must be in the same segment as the printer. Also, settings can be done only when the
printer's arp+ping IP setting is set to Enable.
Use TM-J7200 TM-J7700 Utility for settings other than the IP address.
Flow of Setup
Change network settings
on setting computer
TM-J7200 TM-J7700 Utility
(See "Utilities" on page 65 .)
Printing the status sheet (check settings)
(See "Printing a Status Sheet" on page 58 .)
Method 1 Method 2 Method 3
Use TM-J7200 TM-J7700 Utility to
perform other settings
(See "Utilities" on page 65 .)
Use arp/ping command to set
printer IP address
(See "Setup using arp/ping com-
mands" on page 45 .)
Finish
Use EpsonNet Config (Web version)
to perform settings
(See "Setup using EpsonNet Config
(Web version)" on page 44 .)