Epson Stylus Pro 9500 Engine, Руководство по обслуживанию

Страница: 199 / 266

EPSON Stylus Pro 9500 Revision A
Adjustment Adjustment Steps 199
"UPDATE" ITEMS
The items you can update are described below.
o Capping Position (See page xx)
o
Head Rank (See page xx)
o Print Position Items (Bi-D Adjustment/Gap Adjustment) (See page xx)
o
Paper Feed Distance (See page xx)
o Mechanical Parameters (See page 182.)
Update concerning the R and L flushing positions, and the top, bottom,
side and rear margins.
o
Ink Parameters
By using this function, the initial filling flag can be set as desired. (“Set” =
Execution of the initial filling sequence the next time the power is turned
on.)
o Dot Shift Mode
This mode sets an offset for the adjustment value in Bi-D adjustment
pattern No. 4. The initial setting is “Single Print.”
C H E C K
P O I N T
The parameters will update and be stored in the Flash
memory on the Main Board the next time the printer is
turned off.
C A U T I O N If “Pair” is set based on the evaluation results, it will
be judged that there is shifting of the adjustment
results in the (Inter row corrections) in Bi-D No. 4, so
the setting should absolutely not be changed in
servicing.
If you change the setting, it will cause color
irregularity (vertical direction), so adequate caution
should be taken.
Update: Ink Parameter
Paper Feed [+]/[-]
Init Ink Charge Flag: SET
Init Ink Charge Flag: RESET
Update Parameter?
Updating Parameter
Enter