Epson Stylus pro 7700m, Руководство по обслуживанию

Страница: 75 / 139

4.1 OVERVIEW
This section describes adjustments required when the printer is disassembled and assembled after repair.
Since this printer has both black and color heads, it needs new adjustments not required for previous printers.
Refer to the following table to perform the appropriate adjustments.
WARNING
r Always perform adjustments in the order indicated.
r After performing destination setting, head angle adjustment, head vertical position
adjustment,
head gap adjustment, or bidirectional adjustment, perform the cleaning
operation for the black and color printheads. The cleaning operation is necessary because
printing sample patterns for these adjustments increases the viscosity of the ink and the
printer will not print the correct value. For instance if you replace the black head, you
must perform the following adjustments in the order shown:
(1) black head angle, (2) black-color head vertical, (3) head gap, (4) Bi-D alignment.
r After removing an ink cartridge, always install a new cartridge immediately. During
adjustments and testing, use the cartridges designed exclusively for service:
Monochrome: 1020626, CMY: 1020627.
Table 4-1. Required Adjustments
Work Contents Adjustment Contents
When replacing the M-4A11
printer mechanism
1. Bi-D alignment adjustment (See Section 4.1.2)
2. Head gap adjustment (See Section 4.1.3)
3. Internal timer reset operation (See Section 4.1.8)
When replacing or
disassembling the
C164 MAIN board or
printer mechanism
1. Destination data writing operation (See Section 4.1.1)
2. Bi-D alignment adjustment (See Section 4.1.2)
3. Head gap adjustment (See Section 4.1.3)
When replacing or
disassembling the
black head (board)
1. Black head angle adjustment (See Section 4.1.4)
2. Black - Color head vertical adjustment (See Section 4.1.5)
3. Head gap adjustment (See Section 4.1.3)
4. Bi-D alignment adjustment (See Section 4.1.2)
When replacing or
disassembling
the color head (board)
1. Color head angle adjustment (See Section 4.1.6)
2. Black - Color head vertical adjustment (See Section 4.1.5)
3. Head gap adjustment (See Section 4.1.3)
4. Bi-D alignment adjustment (See Section 4.1.2)
When replacing or
disassembling both the
color and black head
1. Color head angle adjustment (See Section 4.1.6)
2. Black head angle adjustment (See Section 4.1.4)
3. Black - Color head vertical adjustment (See Section 4.1.5)
4. Head gap adjustment (See Section 4.1.3)
5. Bi-D alignment adjustment (See Section 4.1.2)
When replacing or
disassembling
the carriage unit
1. Platen gap adjustment (See Section 4.1.7)
Stylus Pro Service Manual Adjustment
Rev.B 4-1