Epson SQ-2550, Руководство пользователя

Страница: 128 / 315

Graphics
With this numbering system, any combination of the eight
nozzles adds up to a decimal number between 0 and 255, and
no numbers are duplicated.
Since there are 24 nozzles in each column, you must make a
calculation for each of the three sections in each column. As
you can see, this method of planning and printing dot graphics
requires considerable calculation. Because triple-density uses
180 columns per inch, printing a single line of triple-density
graphics only one inch long requires 540 numbers. Fortunately,
commercial software can do the calculations for you.
Before you can put these numbers in a graphics program,
however, you need to know the format of the graphics
command.
The graphics command
The graphics mode command is quite different from the other
commands used by the printer. For most of the other printer
modes, such as emphasized and double-width, one ESCape
code turns the mode on and another turns it off. For graphics,
the command is more complicated because the code that turns
on a graphics mode also specifies how many columns it will
use. After the printer receives this code, it interprets the next
numbers as nozzle patterns and prints them on the paper.
Your printer has one command that allows you to use any of
the 11 graphics options. The format of the command is:
ESC * m n1 n 2 data
Software and Graphics
4-13