Epson PX650 Series, Руководство по обслуживанию

Страница: 103 / 166

Epson Stylus Photo PX650/TX650/TX659/PX660/PX660 Premium/Artisan 635 Revision C
DISASSEMBLY AND ASSEMBLY Disassembling the Printer Mechanism 103
Confidential

Removal procedure
1. Remove torsion springs (x3) at the rear of the printer.
Figure 4-99. Removing the Upper Paper Guides (1)
2. Peel off the mist sheet A and mist sheet B with a tweezer or a similar tool.
Figure 4-100. Removing the Upper Paper Guides (2)
3. Release the hooks (x3), release the Upper Paper Guides from the shaft holders of
the printer frame, lower the actuator of the PE Sensor, and remove the Upper
Paper Guides.
(See Figure 4-99.)
Figure 4-101. Removing the Upper Paper Guides (3)
C A U T I O N
The mist sheet A and B may be deformed or damaged when once
removed. If these are deformed or damaged, replace them with a
new one.
C A U T I O N
When removing the Upper Paper Guides, put down the actuator
of the PE Sensor toward the front to avoid damaging it.
PE Sensor
Upper Paper Guides
Hook
Rear Spring
Mist sheet A
Mist sheet B
Rear
Install the springs properly, while paying attention to the tip
position of each spring.
Figure 4-102. Installing the Upper Paper Guides
A D J U S T M E N T
R E Q U I R E D
After removing/replacing the Upper Paper Guides, make the
specified adjustments. (See
Chapter 5 "ADJUSTMENT" .)
Release the hooks and lift
the Upper Paper Guides
Put down the actuator C A U T I O N
Front
Rear
Hook
Tip of spring
Spring