Epson Mobilink TM-P60, Техническое справочное руководство

Страница: 64 / 148

4-2 Application Development Information Rev. B
4.1.3 Operation tested Access point products
The Access points that have been evaluated with the TM-P60 with Peeler are in the following
table..
4.2 About the Battery Remaining Amount
4.2.1 The battery remaining amount
This printer has a battery to supply power. The battery has four statuses:
*When an AC adapter is connected to the printer, the “battery LED condition” is always Off.
4.2.2 The method to confirm the battery status
The battery status can be confirmed by every control method.
4.2.2.1 OPOS
In OPOS, the battery status can be confirmed by Direct I/O method
“PTR_DI_GET_BATTERY_STATUS.” This information is described in the manual “Application
Developement Guide POS printer (TM Series):
(4.3 StatusUpdateEvent regarding Battery Status.) ”
This manual is installed with OPOS.
Vendor Model A/P firmware RF firmware
Power Managiment
funtion with TM-P60
Symbol AP-4121-1150-US 0.252-13 V2.51-08 Impossible
Symbol AP-4131-1050-WW 0.350-33 F3.10-04 Possible
Vender Model Software Ver. Boot ver.
Power Managiment
funtion with TM-P60
Cisco Air-AP1120B-A-K9 12.2 (13)JA1 12.2(8)JA Impossible
Battery Status
The battery
LED condition
Description
Level H (High) Off The remaining battery charge is between 100% and approximately
50% when the amount of difference between the full battery and
level L is 100%.
Level M
(Medium) Flashing The remaining battery charge is between approximately 50% and
level L when the amount of difference between the full battery and
level L is 100%.
Level L (low) On The battery needs to be replaced or recharged because the
remaining battery charge is low.
Level S (Serious) On The printer will not operate because the remaining battery charge
is too low.