Epson ME100, Руководство по обслуживанию

Страница: 112 / 135

EPSON Stylus CX1500/ME100 Revision A
ADJUSTMENT Overview 112
5.1.2 Adjustment Program feature
We are now making the Adjustment Program.
5.1.3 Adjustment Except Adjustment Program
Following is adjustment except Adjustment Program.
5.1.4 Timing Belt Tension Adjustment
V
Parts to be Removed and Replaced
T
Removal and Replacement of CR Motor
T
Removal and Replacement of Print Head
V
Adjustment procedure
1. Make sure that the printer is turned off.
2. Move the Carriage Unit to the right side until the right side of Carriage Unit
touches to the flag of Cap Slider (white color).
Figure 5-1. Moving the Carriage Unit
3. Press the POWER button of Digital Tension Gauge. (No. 0 or No. 1 will
appear in the LCD.)
4. Select the channel for making further settings by pressing the SELECT button
for a number from No. 0 ~ No. 9. (Not selecting a number continues default
values without a problem.)
5. Press the WEIGHT button. The default value will appear. Enter “0.7g/m” by
means of the buttons on the Gauge.
6. Press the WIDTH button. The default value will appear. Enter “3.0mm” by
means of the buttons on the Gauge.
7. Press the SPAN button. The default value will appear. Enter “335mm” by
means of the buttons on the Gauge.
8. Bend down the sensor cable of Digital Tension Gauge and place it as Figure 5-2 .
T
X direction : Above the Timing Belt.
T
Y direction : Match the Gauge position with the hook of Holder Shaft Unit.
T
Z direction : 10±5mm away from the Timeng Belt.
(Match the Gauge position with the bending line of Main
Frame.)
C A U T I O N
T
Take care not to push up the Slider Cap of Cap Unit by pushing
the Carriage Unit too much.
T
Place the edge side of HP Sensor Lever as Figure 5-1 .
Flag
Edge side of
HP Sensor Lever