Epson EQUITY II+, Руководство пользователя

Страница: 24 / 151

.4. Connect the other end of the cable to the printer as shown in Figure 1-9.
To secure the cable, tighten the squeeze locks at each side of the printer
port and push them into the connectors on each side of the cable.
Figure 1-9.
Connecting the
printer
5. Plug the printer’s power cable into an electrical outlet.
Serial interface
If you have a printer (or another peripheral such as a modem) with a
serial interface, connect it to the serial (RS-232C) port at the back of the
main unit. The Equity II-+ uses a DB-9P connector, so be sure you have an
AT-compatible cable (or an adapting cable that converts the 9-pin output to
the standard 25-pin output). To connect a serial device, follow the same steps
above for connecting a parallel device.
You need to ensure the serial port is set up so it functions properly. If you
are using the port for a serial printer, you must also redirect printer output to
the serial instead of the parallel port. Use the MS-DOS SETMODE program
(or the MODE command) to make these changes. See your MS-DOS man-
ual for instructions,
1-12
User’s Guide