Quick Start Guide: Shadow Elite Client Workstation
Small Form Factor
This sheet covers the installation of the Valerus Elite Client Workstation small form factor. This system should
only be installed by a qualified technician using common hand tools and approved materials in accordance
with the National Electrical Code ANSI/NFPA 70, state and local wiring codes.
Unpacking and Installation
Unpack the unit and place it in the mounting location. Hard drives are preinstalled from the factory.
•
Keyboard and mouse are included with the unit.
•
Connect monitor(s) using the DP or HDMI ports (refer to figures above). DP to HDMI adapters are included as
needed.
Note
: If the system includes the Quad Monitor Support option, connect the monitors using the four mini-DP
ports on the add-on card (see picture above). Do not connect monitors to the onboard video connectors.
Use the mini-DP to HDMI adapters provided in the box.
•
Connect unit to the network using the WAN (Internet) port. Refer to figure above. The port is setup to
procure an IP address automatically using DHCP.
•
Attach the power cord and power the unit on. It is recommended to use an Uninterrupted Power Supply
(UPS) to prevent data loss/corruption and/or drive failures due to sudden power loss.
VICON INDUSTRIES INC. TEL: 631-952-2288 FAX: 631-951-2288 TOLL FREE: 800-645-9116
24-Hour Technical Support: 800-34-VICON (800-348-4266) UK: +44 (0) 1489 566300 WEB: vicon-security.com
Vicon part number
8009-8323-70-00
Product specifications subject to change without notice. Copyright ©2021. All rights reserved.
Vicon and its logo are registered trademarks and Valerus and its logo are trademarks of Vicon Industries Inc.
Front Panel Connections & Controls (i3)
Front Panel Connections & Controls (i7)
Rear Panel Connections & Controls (i3)
Rear Panel Connections & Controls (i7)
