Epson EPL-N4000, Руководство по обслуживанию

Страница: 52 / 306

EPSON EPL-N4000/EPL-N4000+ CHAPTER 1 Product Description
Rev.B 38
LIMITATIONS ON PAPER EJECT UNITS
Multibin (including when Multibin = Stacker and Out Bin = Stacker)
If the Page Size settings are MON, C10, DL, C5 and CTM or the
Type settings are Trnsprncy and Label, the message “Outbin Select
Error” is displayed and paper is ejected to Face-down. This is the
same as when the paper-fed tray size and type are those
aforementioned.
Finisher:
If the page size setting is F4, GLT, IB5, (postcard), MON, C10, DL,
C5 or CTM, the warning “Outbin Select Error” appears and paper is
ejected to Face-down. The same occurs if the paper-fed tray size is
any of the above. At this time, staple designation is ignored.
The number of sheets and the number of copies that can be held in
bin 1, bin2 and bin 3 are limited by the paper size and staple
designation.
Limitation of the number of sheets
In A4-size, the bin becomes full with 670 sheets (TBD).
Staple designation has no effect.
In A3-size, sheets are counted as double the above.
Limitation of the number of copies
If stapled copies are mixed, the bin becomes full with 100 copies
at maximum (TBD) in both A4 size and A3 size. Offset stacking
is not considered.
However, the bin also becomes full with the full sensor. If there is paper
in a finisher bin when the power is turned on, the bin becomes full with
approx. 400 sheets.
The above counted value and the last paper ejected bin are not be
stored in NVRAM. The number of sheets and the number of copies
ejected are reset when the power is turned on.
The number of sheets and the number of copies ejected are reset with
no paper detection. Users should remove all paper from the stacker in
advance when printing a large quantity of copies.
Table 1-41.
PRINTING MENU/QUANTITY
This is the copy quantity setting when copying by quantity. This setting
is specified taking preference over the Copies setting. When the printing
quantity is 2 or more, the Copies setting will be 1. This setting can be
specified only with the PJL, EJL, or ESC/Page command and the
setting cannot be stored. If data for 1 job cannot be stored in the printer,
the warning “Collate wad disabled” will be displayed and a quantity of 1
only will be printed.
PRINTING MENU/DUPLEX
Duplex printing or one-side printing is set.
Limitations on duplex printing
When the Page Size settings are A5, HLT, MON, C10, DL, C5 and
CTM or the Type settings are Trnsprncy and Label or Paper Source
is ENV Tray, the message “Can’t Print Duplex” will be displayed and
printing cannot be started. This is the same as when the size and
type of the tray for which an attempt is made to feed paper are those
aforementioned. If the paper type settings for the face and back
differ from each other, a “Can’t Print Duplex” error will result.
Paper size Without stapling With stapling
LT, HLT, EXE, A4,
A5, B5 670 sheets 100 copies (TBD)
LG, GLG, B, A3, B4 300 sheets 100 copies (TBD)