Epson Endeavor P60, Руководство пользователя, Страница: 42 / 135

Using a Password
If you set a password in the Setup program, you’ll see the
p r o m p t , E n t e r C U R R E N T P a s s w o r d : w h e n e v e r y o u t u r n
on or reset your computer. (If you press
F1
to enter Setup,
you’ll see the prompt after you press
F1.)
When you see the
prompt, type your password and press Enter; the computer
loads the operating system or starts Setup.
If you don’t enter the correct password, nothing happens and
you cannot access your system. You can try to enter the correct
password as many times as you like.
Note
If you want to change or delete your password, you must
run the Setup program as described in Chapter 2.
If you do not remember your password, you must change
the setting of a jumper on the main system board. See
Chapter 4 for instructions.
Changing the Processor Speed
Your computer’s processor can operate at two speeds: high
(60 MHz) or low (simulated 8 MHz). Low speed is available to
provide compatibility with older application programs.
You should use high speed for almost everything you do
because your programs will work faster. However, certain
application programs have specific timing requirements and
can run only at the slower speed. See your software manual to
determine if this is the case.
Using Your Computer 3-3