PSB No: S-0171
Page: 3 of 5
8. General Installation Tips:
Hardware:
The Discovery CD 16 uses a Sound Blaster 16 sound card. The product was
used in its default configuration. The following are the factory defaults:
Feature:
Jumper position:
Setting used:
Base I/O address
IOS0 closed
220( H)ex
Midi address
IOS1 closed
330( H)ex
Board Interrupt
IS0 open
IS1 closed
IRQ5
8-bit DMA channel
DAS0 open
DAS1 closed
Channel 1
16-bit DMA channel
DBS0 closed
DBS1 closed
Channel 5
Joystick port
JYEN closed
Enabled
Audio Output Amp
OPSL pins 2 & 3 closed
Audio amplified internally:
OPSR pins 2 & 3 closed
no external amp needed
These settings can be found in the ‘GETTING STARTED’ manual that comes
with the product. The system uses a Matsushita model CR-563-B CD-ROM
drive. From the factory the drive ID is set to 0. This jumper is on the rear of the
drive between the power connector and the data/ribbon cable.
