Epson EMP-TW100, Руководство пользователя

Страница: 9 / 68

7
Basic Operations
Procedure
1
Turn on the power for all equipment
connected to the projector.
For a video source, press the [Play] button at the
video source to start playback if necessary.
Check that the
indicator on the projector has
stopped flashing and lights orange.
2
Press the [Power] button on either the
remote control or the projector's
control panel to turn on the power.
The indicator flashes green, and after a short
period projection starts.
Check that the
indicator has stopped flashing
and lights green. (This takes approximately 15
seconds.)
3
If more than one signal source has been connected, use the remote control or
control panel buttons to select the port which the signal source that you
would like to use is connected to, while referring to the following table.
*The display disappears after 2 seconds.
Turning On the Power and Projecting Images
The buttons on the remote control and the projector's control panel cannot be operated
while the
indicator is flashing green. Wait until it lights steadily.
The message "No-Signal." may appear depending on the projector's menu settings. (p.30)
Port
Button to press
Display at top-right of
screen *
Projector Remote control
InputA
[Source]
[A] INPUT A
InputB [B] INPUT B
S-Video [S-Video] S Video
Video [Video] Video
D-RGB/A-RGB DVI-I
[D-RGB] D-RGB
[A-RGB] A-RGB
••••
If only one signal source has been connected, the signals from that source will be
projected without needing to press one of the above buttons.
••••
If the "No-Signal." message does not disappear, check the connections again.
••••
If a laptop computer or a computer with an LCD screen has been connected to the
projector, the images may not be projected straight away. After making the connections,
check that the computer has been set up to output signals.
The following table shows examples of how to toggle output settings. For details, refer to
the section of the documentation provided with your computer under a heading such as
"External output", "Connecting an external monitor" or similar.
Lights green
Remote control
NEC Panasonic Toshiba IBM Sony Fujitsu Macintosh
[Fn]+[F3] [Fn]+[F3] [Fn]+[F5] [Fn]+[F7] [Fn]+[F7] [Fn]+[F10]
After startup, change the
Control Panel adjustments
so that Mirroring is active.
Connecting the Power Cord
Turning On the Power and Projecting Images