Epson EMP 51 - SVGA LCD Projector, Инструкция по эксплуатации

Страница: 69 / 82

67
1.
Switch off power to the projector and
disconnect the power cord after cool-down*
ends.
Cool-down time varies according to external
temperature and other factors.
2.
After the projector has cooled completely,
remove the lamp cover.
• The projector requires approximately 60
minutes to cool completely.
• Press on the 2 catches and pull the cover
out diagonally.
3.
Pull the lamp out.
Use a screwdriver to loosen the two lamp
retaining screws, then grasp the holds and
pull the lamp out.
4.
Install a new lamp.
Align the lamp properly, insert the lamp
until it contacts the rear of the housing, and
use a screwdriver to tighten the two lamp
retaining screws firmly.
5.
Install the lamp cover.
Insert the cover diagonally and press it into
the projector until you hear the catches click
into place.
Check that the catches are securely fastened.
Tip:
After lamp replacement, use the About menu to
reset lamp time to its initial value (See page 50).