Epson EMP-503 - SVGA LCD Projector, Руководство пользователя

Страница: 57 / 111

Projector Status Indicators
■ ■ ■ ■ ■ ■
41
Red Lit The projector has turned off automatically
because of over heating.
The lamp goes off automatically and
projection becomes impossible. Wait for
approximately 5 minutes with the
projector in that state. After 5 minutes has
passed, pull out the power plug once,
then insert it again.
If the projector overheats, check the
following 2 points and make the
necessary improvements.
• Is the projector installed in a place with
good ventilation?
Make sure the air intake and exhaust
vents are not covered, and that it is not
placed up against the wall.
• Has dust accumulated in the air filter?
If the air filter is dirty, clean it.
When the power plug is reinserted, the
projector will recover to the normal state,
so press the power button and turn on the
power again. If the projector overheats
again even when the above measures
have been taken, and when an error is
displayed in the indicator when the power
is turned on again, discontinue use, Pull
the power plug out of the receptacle then
request repairs by the retail shop where
you purchased it, or by the service office
at the nearest address provided on
page 79.
Red Flashing There is a problem with the cooling fan or
temperature sensor.
Pull the power plug out of the receptacle
then request repairs by the retail shop
where you purchased it, or by the service
office at the nearest address provided on
page 79.
Color Status Meaning
Downloaded from: http://www.usersmanualguide.com/