Epson EB-1750, Руководство пользователя, Страница: 113 / 149

Using the Mail Notification Function to Report
Problems
When you set Mail Notification, notification messages are sent to the preset
email addresses when a problem or warning occurs with a projector. This
will enable the operator to be notified of problems with projectors even at
locations away from the projectors.
s
Network - Mail - Mail Notification p.82
a
•
Up to a maximum of three notification destinations (addresses) can
be registered, and notification messages can be sent to all three
destinations at once.
•
If a projector develops a critical problem and suddenly stops
working, it may not be able to send a message notifying an operator
of the problem.
•
If you set Standby Mode to Communication On , you can control
the projector even if it is in standby mode (when the power is
off).
s
Extended - Standby Mode p.74
Reading Error Notification Mail
When the Mail Notification function is set to On and a problem or warning
occurs in the projector, the following email will be sent.
Subject: EPSON Projector
Line 1: The projector name where the problem has occurred
Line 2: The IP address set for the projector where the problem has
occurred.
Line 3 and on: Details of the problem
The following messages are listed line by line to indicate the details of the
problem. See the following to deal with problems or warnings.
s
"Reading the Indicators" p.88
•
Internal error
•
Fan related error
•
Sensor error
•
Lamp timer failure
•
Lamp out
•
Internal temperature error
•
High-speed cooling in progress
•
Lamp replacement notification
•
No-signal
•
Auto Iris Error
•
Power Err. (Ballast)
A (+) or (-) appears at the start of the message.
(+): A projector problem has occurred
(-): A projector problem has been dealt with
Management Using SNMP
By setting SNMP to On , notification messages are sent to preset email
addresses when a problem or warning occurs. This will enable the operator
to be notified of problems with projectors even at locations away from the
projectors.
s
Network - Others - SNMP p.82
a
•
SNMP should be managed by a network administrator or someone
who is familiar with the network.
•
To use the SNMP function to monitor the projector, you need to
install the SNMP manager program on your computer.
•
The managing function using SNMP cannot be used via wireless
LAN in Quick connection mode.
•
Up to two destination IP addresses can be saved.
Monitoring and Controlling (EB-1775W/EB-1770W/EB-1760W Only)
113