Epson Advanced Printer Driver for TM Series Ver.3.04, Руководство по установке, Страница: 37 / 62

Rev.B APD Installation and Setup 2-19
Advanced Printer Driver Installation Manual
Adding or Removing Printers
To add a printer to the computer or remove a printer that is no longer necessary from the
computer, follow the procedures below.
Adding a printer
To add a printer, install the printer driver and configure the port by following "APD Installation
and Printer Driver Setup" on page 2-5 .
Note:
You cannot add the printer driver directly from the Printers and Faxes screen.
When connecting a USB printer, you cannot add the printer driver using the Windows plug and
play feature.
Removing a printer
To remove the driver of a printer that is no longer necessary from the computer, uninstall the
printer driver by following "Uninstalling a printer driver" on page 2-27 .
Replacing a printer
When replacing a printer for another of the same model and same interface due to repair, for
example, note the following points.
Make sure the DIP switches on the new printer are configured with the same settings as those on
the replaced printer, regardless of the interface.
❏
Serial If the DIP switch settings for serial communication are the same, no
configuration is necessary following the replacement.
❏
Parallel No configuration is necessary following the replacement.
❏
USB If the printer's interface card changes because the printer is changed, the
APD recognizes it as a new printer connection and therefore generates a
new Epson Port (USB). For this reason, you must configure the newly
generated Epson Port with the same settings as those of the Epson Port to
which the printer driver was assigned.
❏
Ethernet No configuration is necessary on the printer driver if the same IP address
as for the replaced printer is used for the new one.