ActionLaser II
Paper Handling Options
The Multi-Media Feeder
The optional multi-media feeder handles automatic feeding of many
types of paper. It holds up to 150
sheets
of paper, and it can feed
paper from 98 to 216 mm (3.86 to 8.50 inches) wide and from 148 to
356 mm (5.83 to 14.0 inches) long. You can load two different sizes of
paper in your printer at once (one size in
the
multi-media feeder and
the
other in your standard paper cassette). You can also set SelecType
Level 1 INPUT to AUTO and use both the multi-media feeder and
the standard paper cassette for continuous printing of up to 250
sheets of the same size paper.
Installing the multi-media feeder
1. Remove the manual feed paper guide.
2. Attach the multi-media feeder as shown below. Then, mount the
multi-media feeder safely on the printer.
Status and Error Messages
If an error occurs, your best source of information is the display
on
the control panel. The messages displayed there tell
you what may be
wrong
and, in some cases, indicate the actions you should take to
correct the problem. Status messages appear on the display during
normal operation. They indicate
the
printer’s current status.
This section contains
an
alphabetical list of status and error messages
you may encounter while printing and includes steps you can take to
correct
any
problems.
Note:
In
some
cases, the
red
CONTINUE light flashes when an
error is
detected. This requires you to correct
the
problem and then press
CONTINUE
to clear the error. However, if the AUTO CONT option in
SelecType is set to on, some errors may clear automatically even
though the
problem remains. In most instances, you should leave
AUTO CONT set to off.
The messages
In this
section, status messages are preceded by [S], error messages
are preceded by [E] and warning messages are preceded by [W]. In
some cases the message you see on your display also shows the
printer mode.
[E] ADD MEMORY FOR U-I-X
This indicates that there is not enough memory in Channel X. See
Chapter 4 for instructions on changing the RX-BUFFER SIZE or
adjusting the memory distribution in the INDIVIDUAL setting or
see Appendix A for adding memory.
[E] CANCEL MANUAL FEED
This message indicates that there is no paper in the manual feed
slot when you are using manual feed. See Chapter 5.
[E] CHANGE PCU XXXXX
Replace the photoconductor unit as described in Chapter 6.
The PCU counter tells you the number of pages that have been
printed.
[S] CHAR CREATING
Characters are being created.
[S] COPY END
Multiple-copy printing is cancelled. (You pressed the
COPY END
button when the printer was off line.)
[E] COVER OPEN
The printer or fan cover is open or the toner cartridge or
photoconductor unit is not installed. Close the printer or fan
cover or install the toner cartridge and photoconductor units.
[S] DATA
The printer has received data but is not yet printing or
the
printer
has received data and is off line. If the printer is off line, press
FEED
to print the data.
[E] FEED JAM
Paper is not feeding into the printer from the specified cassette or
has jammed on its way into the printer. See the FEED JAM section
in this chapter for information.
[S] FONT CREATING
A font is being created.
[S] GRAPHIC DRAWING
Graphics are being drawn.
[E] ILLEGAL CARD
A card in the card slot or a cartridge in
the
cartridge slot cannot
be read. To correct this error, take the printer off line and then
press
CONTINUE.
If the error
message
remains, make sure the
printer is off line and remove the card or
the
cartridge. If
the
red
CONTINUE
light still flashes, press
CONTINUE.
[S] INITIALIZE
The printer is being initialized to the factory or optional settings.
Laser Printers
9/17/91
ALll-7
