EPSON Stylus PHOTO 875DC
Revision A
ADJUSTMENT
Adjustment
44
6.
Turn the printer power off. The power LED (green lamp) on the panel
blinks once and the printer begins to load the firmware to the flash
ROM on the card reader. When the power LED starts blinking, it
means the writing is done. (It takes about ten seconds for the writing
operation to be completed.)
7.
When the operation is executed, turn the printer power off.
8.
Set the jumper JP2 as shown below:
1 - 2 : Open
3 - 4 : Short
9.
Mount the “Shield Plate, P/B, Upper” on the card reader.
10. Install the Housing.
5.2.3.3 Checking for the Memory Card Drive Firmware
Version
Use this function to check for the memory card drive firmware version.
1.
Start the service program and access the main menu window.
2.
Select
Firmware Checksum
. The Memory Card Drive Firmware
Checksum window appears.
Figure 5-8. Memory Card Drive Firmware Checksum Window
3.
Click OK, and the memory card drive firmware version is indicated.
Содержание 875DC - Stylus Photo Color Inkjet Printer
