Epson 835p - PowerLite XGA LCD Projector, Руководство пользователя

Страница: 138 / 210

138
Managing Projectors
Connecting and Configuring the
Projector on a Network
Before using the EasyManagement software to manage your
projector(s), you have to connect each projector you want to monitor
to your network and configure it with an appropriate IP address. You
can connect and configure the projector wirelessly, as described on
page 59, or you can connect it using the network port.
Follow these steps to connect and configure the projector for your
network.
1. Connect the projector to your network using a commercially
available 100baseTX or 10baseT network cable.
2. Turn on the projector (see page 18).
3. Press the
EasyMP
button on the remote control and press
Enter
.
Use the remote to highlight
Basic
under
Wired LAN
or
Wireless LAN
.
4. If your network assigns addresses automatically, turn on
DHCP
.
If your network does not assign addresses automatically, turn off
DHCP
and enter the projector’s
IP Address
,
Subnet Mask
, and
Gateway Address
, as needed.
To enter numbers using the remote control, press the
Num
button until it lights, then use the number keypad shown below.
note
If you’re a network
administrator, you can use
the
SNMP
option to enter a
trap IP address. This lets you
receive trap alerts for the
projectors you’re monitoring.
You can also configure your
wireless network to receive
trap alerts. Your projector
must be connected in Access
Point mode. Select the
SNMP
button next to the
Access Point mode box and
enter the IP addresses of the
computers to be notified of
an SNMP trap.