Epson 821p - PowerLite XGA LCD Projector, Руководство пользователя

Страница: 89 / 114

Solving Problems
89
Solving Password Problems
You have forgotten the password.
■
Write down the request code that appears in the Password Protect
Release screen and contact Epson. See “Where To Get Help” on
page 91.
■
If you turned on the password protect feature before setting the
password and no password was set before, try using the default
password:
0000
.
The remote control is not available.
You must have the remote control to enter the password. If necessary,
you can purchase a replacement remote control from Epson. See
page 91 for details about ordering.
Solving Problems with the Remote
Control
The projector doesn’t respond to remote control commands.
■
Make sure you are within 20 feet of the projector, and within
range of the projector’s front or back sensor (approximately 30° to
the left or right and 15° above or below).
■
The remote control batteries may not be installed correctly or may
be low on power. Replace the batteries as described on page 48.
■
Dim the room lights and turn off any fluorescent lights. Make
sure the projector is not in direct sunlight. Strong lighting,
especially fluorescent lights, may affect the projector’s infrared
receivers.
■
Turn off any nearby equipment that emits infrared energy, such
as a radiant room heater.
■
The
P
Power
button is disabled while the
Power
light is
flashing. Wait for the light to stop flashing.