Epsolar Tracer-1206RN, Инструкция по эксплуатации, Страница: 9 / 33

5
Step 1: Choose Mounting Location
Locate the Tracer on a vertical surface protected from direct sun, high
temperature, and water.
Step 2: Check for Clearance
Place the Tracer in the location where it will be mounted. Verify that there is
sufficient room to run wires and that there is sufficient room above and below the
controller for air flow.
Figure 3-1 Mounting and cooling
Step 3: Mark Holes
Use a pencil or pen to mark the four (4) mounting hole locations on the mounting
surface.
Step 4: Drill Holes
Remove the controller and drill four sizeable holes in the marked locations.
Step 5: Secure Controller
Place the controller on the surface and align the mounting holes with the drilled
holes in step 4. Secure the controller in place using the mounting screws.
3.3 Wiring
NOTE: A recommended connection order has been provided for maximum
safety during installation.
NOTE: The Tracer is a negative ground controller. Any negative connection of
solar module, battery or load can be earth grounded as required. Grounding is
recommended.
Warm air
150mm
150mm
Cool air