Description of the drawings:
1.
230V plug
2.
Battery connector:
red = Battery (+)
black = Battery (-)
3.
Temperature sensor (see the following table)
Any temperature sensors used are only active if the battery charger
temperature compensation parameters have been set to values other than
zero. We recommend to fix the temperature sensor to one of the battery
terminals.
The charger EPS 1001 can be delivered with two separate outputs. The two
outputs have no galvanic connection. In case of for example 24V charger
with two outputs, they may serially be connected to a 48V string of batteries
(each one to 24V string). With this option the batteries get better charge
equalization. When viewing the charger from the rear, where the battery
cables exit the housing, the output number one is in the middle and output
number two at the top.
Pin Function Pin Function
1, 2 Temperature sensor 1, 2 Temperature sensor for output 1
3, 4 Temperature sensor for output 2
Single output
EPS 600/1000
(Molex type connector)
Double output EPS 1000
IMPORTANT:
The battery connectors carry large currents. The contacts and the
whole connector gets very hot if the contacts/connector are not fitted
properly. We strongly recommend the use of proper tools. The connection
should be done by qualified personnel.
The charger has to be checked for mechanical damages on the housing or
cables/connector before use. If any defects are found, then the charger can
not be put into operation.
EPS 601-X
EPS 601-X
EPS 1001-X
