Battery chargers EPS 600 and EPS1000 are modem fully automatic
devices suitable not only for charging but also for maintaining and
monitoring the batteries. Charger stores data about charging times and Ah
counting. This data may be accessed for further analysis.
The charger may be used as a stationary device or can be installed and
operated in the vehicles. Charger should be mounted horizontally. Any
drilled holes or any mechanical changes of the housing may damage the
charger.
Your EPS battery charger was factory programmed for a specific battery
type. Make sure the charging profile suits your battery type. To change the
charging profile for a specific battery type, parameters may be
programmed with a PC software package and a programming interface.
The programming parameters allow the charger' s profile to suit the battery
type. Up to five charging phases can be programmed. The charging
voltages, currents, charging times, temperature compensation and other
control functions can be programmed. Please contact your dealer for
further information. By programming the charging profile always follow the
battery producer instructions regarding voltages, currents and charging
times.
Read the operating instructions carefully before using the EPS
Battery charger.
Note: Please note, that new batteries reach the maximum capacity after
multiple charging cycles have been completed successfully. Old batteries
often don't reach the full capacity. This can cause the charging process not
to end properly (example:
maximum charging time overflow).
TO START THE CHARGING PROCESS
Establish a safe connection between the battery and charger first. Then
plug the mains connector. This sequence must always be followed in this
order. When removing the connection, remove the mains plug from the
mains first before disconnecting the battery circuit.
After connecting the battery, the red LED (error LED) flashes several times
and then remains OFF. By starting the charging the yellow LED lights ON
(also a click the inside relay can be heard and cooling fan starts to operate).
Whenever you are handling or working with a lead-acid battery, consult your
battery owners' manual for instructions and safety precautions.
COOLING FAN
Do not cover the cooling fan openings to ensure enough cooling flow.
Otherwise the charging current will drop and the charging time will increase
proportionally.
Use the charger for the defined battery type only, (according to the
parameters). If the charging profile does not suit the battery type, the
battery will not be charged properly and the life time of the battery may be
shortened.
BATTERY TYPE
Use the charger for the define battery type only, (according to the
parameters). If the charging profile does not suit the battery type, the
battery will not be charged properly and the life time of the battery may be
shortened.
GAS
Lead-acid batteries produce hydrogen-oxygen gases which can be
explosive and sulfuric acid that can cause severe burns. Make sure working
area is well-ventilated. Cigarettes or any open fires or sparks may cause an
explosion. Keep all ignition sources away from the battery.
ACID
Battery acid can severely damage your eyes and skin. In event of accident,
flush with water and seek medical help immediately. Use proper personal
protective devices when handling a damaged or leaking battery. Treat
material used to clean up a battery acid spill as hazardous waste.
TOXIC SUBSTANCES
Batteries contain hazardous materials. Among others lead and antimony
are toxic substances. Waste lead-acid batteries are hazardous waste and
must be treated according to the Battery Disposal Regulations.
OPERATING INSTRUCTIONS
BATTERY CHARGER EPS 600 AND EPS 1000
IMPORTANT FOR YOUR SAFETY!
