epro Combi Machine, Руководство пользователя

Страница: 28 / 34

After milling, allow the unit to
run longer and blow out.
The wrong type of tool causes
excessive material removal.
Check type and replace if
necessary.
5 Electrodes are not
milled, not milled
enough during the
first run of the
device or not
properly released
in the extraction
tool.
Incorrect or defective milling
insert or extracting tool.
Check and replace parts if
necessary. Important factors
such as milled radius should be
captured only with precision
measuring devices.
5a Electrodes are not
milled or not
milled enough
during the first run
of the device.
Cutting speed too low due to
low power or transmission.
Please refer to 1 – 3
Closing force of the welding
guns too low.
Gradually increase closing
pressure.
Milling time too low. Gradually increase milling time.
6 Electrodes not
suitably milled.
Please refer to 5 Please refer to 5
Milling insert clogged. Clean milling insert. Please
refer to 4.
Milling insert no longer wears
due to excessive oil / grease
residues.
Clean the milling insert with
solvent.
Milling insert damaged by
welding current.
Replace parts Make sure that
no current is triggered during
milling.
Worn edges in the milling
insert.
Check and replace part.
7 Different service
lives, although
Please refer to 6 Please refer to 6