Epple Maschinen GB 32, Руководство пользователя

Страница: 28 / 54

Stand 02.01.09, GB 32, Geared head drill Page 28 of 54
4.3 Activating the machine
The activation of the machine happens in 4 steps.
4.3.1 Main switch
By activating the main switch you supply the machine with current (view
main switch lockable).
4.3.2 Release EMERGENCY STOP control
By turning the EMERGENCY STOP switch in direction it jumps out of its
locking. Now the machine is ready for operation.
4.3.3 Turning direction choice
Above the main switch is the turning direction/ driving speed choice lever
for the main motor. First of all, turn this switch at position 1 to the right.
4.3.4 Driving speed choice
At the gear box are located right above 2 choice levers. The left lever
(area D
– 0 – E) is for the abrasive value, the right lever (area A – B – C)
fort he fine value (view table overview control elements mechanical).
The pre - selection of a driving speed only may happen during stoppage
of the machine.
4.3.5 Close chip protection
Click the chip protection in front of the drilling spindle like pictured in
picture 7.
4.3.6 Activating
The machine is connected by using the on
– switch of the main switch (view
overview control elements electrical) at the control panel.
Push therefore shortly the green switch [I].
The drilling spindle starts with the chosen number of speeds.
4.3.7 Deactivating
If you push the red switch „off“ or click off the chip protection, the drive
gets deactivated. All control elements stay active.
If you push „EMERGENCY STOP“ happens the same, but the complete
control of the machine is deactivated.
You can disconnect the machine from the grid with the main switch.