EPOX EP-7KXA, Руководство пользователя, Страница: 39 / 73

BIOS
EP-7KXA
Page 4-13
Secondary Slave UDMA : This allows you to select the mode of operation for
the hard drive. The default is Auto.
Auto : The computer will select the optimal setting.
Disabled : The hard drive will run in normal mode.
Init Display First: If two video cards are used (1 AGP and 1 PCI) this specifies
which one will be the primary display adapter. The default is PCI Slot.
PCI Slots : PCI video card will be primary adapter.
AGP: AGP video card will be primary adapter.
IDE HDD Block Mode : IDE Block Mode allows the controller to access blocks
of sectors rather than a single sector at a time. The default is Enabled.
Enabled : Enabled IDE HDD Block Mode. Provides higher HDD transfer rates.
Disabled : Disable IDE HDD Block Mode.
Onboard FDD Controller : This controls the state of the onboard floppy
controller. The default value is Enabled.
Enabled : Enable the Onboard VIA686A Chips’s floppy drive interface controller.
Disabled : Disable the Onboard VIA686A Chip’s floppy drive interface controller.
Onboard Serial Port 1 : This field allows the user to configure the 1st serial
port. The default is Auto.
AUTO : Enable Onboard Serial port 1 and address is Auto adjusted.
COM1 : Enable Onboard Serial port 1 and address is 3F8H/IRQ4.
COM2 : Enable Onboard Serial port 1 and address is 2F8H/IRQ3.
COM3 : Enable Onboard Serial port 1 and address is 3E8H/IRQ4.
COM4 : Enable Onboard Serial port 1 and address is 2E8H/IRQ3.
Disabled : Disable Onboard SMC CHIP’s Serial port 1.
Onboard Serial Port 2 : This field allows the user to configure the 2nd serial port.
The default is Auto.
AUTO : Enable Onboard Serial port 2 and address is Auto adjusted.
COM1 : Enable Onboard Serial port 2 and address is Auto.
COM2 : Enable Onboard Serial port 2 and address is 2F8H/IRQ3.
COM3 : Enable Onboard Serial port 2 and address is 3E8H/IRQ4.
COM4 : Enable Onboard Serial port 2 and address is 2E8H/IRQ3.
Disabled : Disable Onboard SMC CHIP’s Serial port 2.