Hardware Setup
13
Clear CMOS Data Jumper (JP3)
To clear the contents of the CMOS, please follow the
steps below.
1. Disconnect the system power supply from the power
source.
2. Set the jumper cap at location 2~3 for 5 seconds, then
set it back to the default position.
3. Connect the system's power and then start the system.
4. Enter BIOS's CMOS Setup Utility and choose Load
Setup Defaults. Type Y and press enter.
5. Set the system configuration in the Standard CMOS
Setup menu.
Onboard Audio (JP4)
This function allows you to enable and disable the on
board audio. You must set the jumper's cap to pins 1-2
to enable or set pins 2-3 to disable this function.
Embedded CODEC Jumper (JP5)
Short pin 1-2 to enable onboard AC`97 CODEC. Short pin
2-3 to enable Soft Audio/Modem riser.
Normal (default)
1
1
Clear CMOS data
Enabled
1
1
Disabled
Soft-Audio/Modem riser enabled
1
AC'97 CODEC enabled
1
