page | 4
www.snapav.com Support 866.838.5052
CONNECT
Strip the insulation on each conductor approximately ¼" and insert
into the speaker terminals. Ensure no strands of wire protrude from the
connectors.
Observe proper polarity for each speaker to the amplifier (
+
to
+
and
–
to
–
).
Refer to the dual voice coil speaker wiring configuration image below
when wiring a dual voice coil speaker.
Amp
Amp (Left)
Amp (Right)
Visit SnapAV.com or contact customer support for help with impedance,
system design ideas, or wiring recommendations.
SECURE
Insert the speaker into the opening and tighten each of the three screws to
clamp the speaker against the wall or ceiling.
Tighten until you feel resistance but do not over tighten. If using a drill, use
a low-torque setting.
www.snapav.com Support 866.838.5052
SINGLE VOICE COIL
DUAL VOICE COIL
Содержание IC-6
Страница 1: ...INSTALLATION MANUAL ARCHITECTURAL SPEAKERS...
Страница 8: ...2015 Episode Rev 150608 1030...