Episode ES-TERRAIN-SAT-2.0, Руководство по установке

Страница: 6 / 12

page | 6
Support 866.838.5052
INSTALLATION
Once you have laid out your plan and marked the positions on the ground, dig the
hole for the subwoofer and set it in place.
Couplers come attached to the satellites. Prior to installing the sattelite onto the
stake, use the provided end cap and place it on top of each stake. Drive the stake
into the ground, removing the end cap once the stake is at the proper depth. Note
that the Quick Connect hole should be to the rear of the intended aim of the speaker.
!
CAUTION:
Do not drive the stake into the ground without using a provided
end cap.
CONNECT
!
CAUTION:
Do connect the speaker wire to the amp until all other
connections except power have been made.
!
CAUTION:
Do not supply power to the amplifier until all other connections
have been made.
NOTE:
The silicone-filled weatherized wire nuts included with this kit are
specially designed for direct-burial installations. An equivalent connector must be
used for any wiring in the system that is exposed to water or weather.
1.
Twist the the source wires to the speaker head wires, then secure them
using the weatherproof wire nuts. Silicone may squeeze out of the wire nut
during this step; leave this on the wire for the most protection.
2.
Attach the speaker head to the stake. Ensure that the wires are not crimped,
that the wires exit the speaker assembly below ground level, and that the
coupler locks into place in the stake.
3.
Wire each channel from the amplifier through each channel on the subwoofer.
IN/OUT are clearly labeled on the burial sub wire. Up to 4 satellites can be wired
in parallel off each side of the subwoofer ma/+ and -/- or all satellites.
Quick Connect Hole to
Rear of Speaker
Coupler