page | 11
© 2019 Episode®
Inline Volume “Thump”
If inline volume thumps, the amplifier and source volume levels are set too high. Inline volume controls
should be calibrated so that they are one or two adjustment levels away from their maximum setting
when audio is at the normal listening level. This will leave one to three settings above normal level for use
if a little extra volume is needed.
SPECIFICATIONS
EA-AMP-HYB-2D-1000
Channels
2-channel
Power Output
300W per channel @ 8 ohm (1000W bridged)
500W per channel @ 4 ohm (2000W bridged)
700w per channel @ 2 ohm
500W per channel @ 70V
500W per channel @100V (230VAC only)
Input Sensitivity
1.4 Vrms, max power
Input Impedance
RCA Analog input: 10kΩ
Balanced Analog input: 20k Ω
Signal to Noise Ratio
101dB A-weighetd @ 1.4 Vms & 4Vms input max
Total Harmonic Distortion (THD)
Less than 1%
Frequency Response
±
2dB at
⅛
th
power (20 Hz to 20kHz)
Inputs
Network: RJ-45 jack, 10/100Mbps
Audio Inputs / Outputs
Bal. Analog Audio:
2 × 3-pos. Phoenix-style pluggable screw term. block
Analog RCA:
White jack (L. Ch), Red jack (R. CH)
Spkr. Output:
2 × 3 pos. Phoenix-style pluggable screw term. block (12-18
AWG)
12 Volt Trigger
3.5 mm Mono Jack
Dimensions (Inches)
17”W x 1.73”H x 14”D
Rack Spacing
1U
Input Voltage
115V AC/230V AC
Weight
12 lbs
Certification
Meets FCC Part 15, UL EN60065
AC Power Consumption
230W Typical
1100W Max