http://www.GuitarAmplifierPCBs.com
Plexi SE PCB Valve Junior Conversion
Version 2
Build Manual
23 August 2009
13 of 34
6.1.3 Drilling the Chassis
Start by setting the center of each hole to be drilled. A center punch is often
used. Use the appropriate drill bit size as prescribed by the drill plan.
Deburr or countersink each hole to ensure no sharp edges will cause injury or
component failure.
7. Plexi SE PCB
7.1 Assemble the Plexi SE PCB
The anticipation has been killing you, hasn’t it? Finally, the assembly of the Plexi
SE PCB begins.
Did you check you make sure you have all of the
parts you’ll need to complete the assembly?
I wish I did.
The graphics used in the assembly of this circuit board will NOT be an
exact reflection of what your board will look like. Various parts will have
changed. The order of installation may vary from the picture and this
manual. Pictures were taken during various stages of the first production build.
This manual reflects the lessons learned during that build.
Don’t use the pictures to compare the progress of your build. Follow the
instructions at each stage of the build and compare your work when the manual
calls out a comparison check.
