![background image](http://html.mh-extra.com/html/epiphan/lecture-recorder/lecture-recorder_install-manual_2417804012.webp)
1. Installation and Getting Started
Connect and Power on a VGA Recorder Lite Device
Page 12
VGA Recorder
To connect and turn on the VGA Recorder Lite device
1
Use a VGA cable to connect the VGA source to the VGA
Recorder Lite VGA IN port.
You can use an active VGA splitter to split the VGA signal
between a monitor and the VGA Recorder Lite device.
Note:
Passive splitters reduce the quality of the VGA signal. Good
quality active splitters, (available from Epiphan) do not usually
affect signal quality. You should use a splitter with the highest
available bandwidth.
Figure 6: Connecting to a VGA source
2
Use a RJ-45 Ethernet cable to connect the VGA Recorder Lite
Eth 1 port to your 10/100/1000 Base-T Ethernet network.
For best performance, connect the VGA Recorder Lite device
to a 1000 Base-T Ethernet. The network must be running the
TCP/IP protocol. Ideally the VGA Recorder Lite device should
be able to connect to the Internet.
3
Connect the power adapter to the VGA Recorder Lite device.
Figure 7: Connecting to the Ethernet network and power
VGA IN
LEDs
Eth 1
Power Input