25. Locate the ORANGE periscope. This is located in the upper left rear corner of the engraver,
behind the side panel that was removed earlier.
Left side of engraver
Arrow denotes the “Periscope”
Diagram 2
26. With your magic marker, draw an up facing arrow on both of the mirror mounting plates, as
shown in the picture. This will make realigning the engraver much easier.
27. Remove the 4 #1 Phillips screws from TOP mirror mounting plate.
28. Gently lift the Mirror mounting plate up from the “periscope”
29. Remove the mirror from the Mirror mounting plate by turning the mirror and the mirror
support counterclockwise.
30. Install the replacement mirror and mirror support on the mirror mounting bracket.
31. Place the Mirror mounting bracket back in the “periscope’ ensuring that the arrow that was
drawn earlier points up. Install the mounting screws
32. Turn on the Red Dot pointer.
33. Move the X-Axis rail to the rear and the lens carriage to the far left hand side of the
engraver.
34. Visually inspect the position of the red dot. Adjust the Top mirror in the “periscope” until the
red dot is centered in the alignment target.
