EPILOG LASER
16371 Table Mountain Parkway
Golden, Colorado 80403
Phone 303-277-1188 - FAX 303-277-9669
www.epiloglaser.com
Procedure Title:
Replacing the Optics in your FiberMark Laser Engraver
Tools Needed:
o
#1 Phillips Screwdriver (For Side Panel)
o
#2 Phillips Screwdriver (for Mirror Mounts)
o
3/32 Allen Wrench
o
1 ea. 5/64 Allen Wrench (for mirror mount over lens)
o
1 ea Magic Marker
Supplies provided:
o
1 ea. Alignment Target, provided with replacement optics
o
3 ea. mounted replacement mirrors
o
1 ea. un-mounted replacement mirror
Note:
o
Due to the construction of the Fiber Laser, this alignment will be performed using the
Red Dot Pointer. There is no need to align the red dot to the laser, as they are
aligned internally in the laser.
o
The laser will be aligned after each replacement optic is installed. This will simplify
the alignment process.
Some conventions
:
o
The front of the machine is where the control panel is located. When facing the front
of the machine, left is your left, and right is your right.
o
After a mirror is replaced, the engraver will be re-aligned. When making alignment
adjustments for this procedure, only make adjustments to the last mirror replaced.
This will simplify the alignment process. Once all of the mirrors have been replaced,
we will double check the entire machine for alignment.
Procedure:
1. Turn off the power to the engraver
2. Unplug the engraver from its power source
