6
1.
Attach the Stabilizer (8) to the Frame (1) with
two M10 x 123mm Button Bolts (38) and two
M10 Locknuts (70) (only one is shown).
Tighten two Leveling Feet (36) into the under-
side of the Stabilizer (8).
2. Have another person hold the Upright (2) near
the Frame (1) as shown.
See the inset drawing.
Locate the wire tie in
the Upright (2). Tie the lower end of the wire tie
to the Wire Harness (77). Next, pull the upper
end of the wire tie upward out of the top of the
Upright. Then, untie and discard the wire tie.
Tip: Use an elastic band or a piece of tape to
prevent the end of the Wire Harness from
falling into the Upright.
Tip: Avoid pinching the wires.
Attach the
Upright (2) to the Frame (1) with four M10 x
25mm Patch Screws (48) and four M10 Split
Washers (85).
1
1
2
48
85
2
1
70
38
8
36
77
85
48
85
To make assembly easier, read the
information on page 5 before you begin
assembling the elliptical exerciser.
Avoid pinching
the wires
Wire Tie
77
