EPAX DX Cure Pro, Руководство пользователя

Страница: 11 / 15

THE PRINTING
PROCESS:
DENTAL MODEL
Section V.
When the printing is done, wait until no more residual resin drips from the platform and wear
gloves before removing it. You can wipe off any residual resin as well.
Our DX series comes with a Flexible Build System. Using the metal tab sticking out from the
platform, you can remove the Flex plate from the brown magnetic base. To remove the print,
simply flex the plate to pop the print off. It’s best to pop the print off directly into the IPA bath
to avoid the print popping off onto the floor or table. Soak the print in at least 91% IPA
(Isopropyl alcohol) for about 10-15 minutes. For some dental resins you may need to leave it in
for longer or agitate the IPA so that the residual liquid resin can be cleaned off.
After your model is clean, put it in a cool, dry, well-ventilated area until it dries, or dry it up with
a air blower. Please make sure to still be wearing gloves during this time. To cure it, you can
insert the model into our DX Cure Pro machine. Set the timer for 180s, and at the end the print
should be good to be used. The print should feel like plastic. If it still feels tacky, or not dry you
may not have let the print dry for long enough, or the environment may be too humid to dry
properly. In this case, consider utilizing a fan to blow on the print while drying.
4: POST-PROCESSING
10
ht
tp
s:
//
ep
ax
de
nt
al
.c
om