EOS SteamAttrac, Инструкция по установке и эксплуатации

Страница: 27 / 72

SteamAttrac - Installation and Operating Instructions 27
Mounting
The following distances must be observed:
3.1.2 Mounting the steam generator
The steam generator is mounted on the wall with four (4) retaining screws
and suitable anchors. Note that the steam generator may vibrate slightly
when the water boils. Ensure that you have sufficient hardware for securing
it if you do not use the supplied screws and anchors.
Necessary steps:

Preparing for installation,

27

Mounting the steam generator,

29
Ha tools:

0.5 m tube with screw, 3/4” female thread

Four 5 x 40 screws; four F6 anchors (included in scope of delivery)

6 mm drill

Phillips screwdriver

Recommendation: 2 persons to mount the steam generator

Preparing for installation
1
NOTICE Ensure that the holes are aligned vertically and horizontally.
Use a spirit level.
Drill two (2) holes above and below.
See

Mounting distances,

26
2
Insert the anchors and screw in the top two screws.

Allow the screws to protrude approx. 3 mm so you can hang the
steam generator on them.
Distance between drill holes Horizontal: 418 mm
Vertical: 240 mm
Distance (side) left and right to the walls 250 mm
Top Min. 250 mm
Bottom Approx. 1000 mm