EOS SBM-LSG-IR, Руководство по установке

Страница: 33 / 72

Relay Box for Infrared Cabins - Installation Instructions 33
Installation
5.2.3 Cabin address – programming button
The Relay Box for Infrared Cabins is programmed with cabin address 1 as
delivered. If multiple cabins are installed, the cabin address must be pro-
grammed accordingly in the respective relay boxes.

Programming button – IR relay box
For more information about installing multiple cabins, see chapter
Installing multiple cabins,

43.
5.2.4 Unit address – ADR DIP switch
Each connected IR module is assigned a unique unit address. Each unit
address must only be assigned once so that the unit can be uniquely iden-
tified.
One IR relay box and 2 IR modules per cabin are supported. Control loops
for the three units are controlled simultaneously.
Typically, the relay box is assigned unit address 1. Additional modules are
assigned addresses 2 and 3 respectively in the IR modules.
A LED B Programming button
B
A
Address 1 (unit 1) Address 2 (unit 2) Address 3 (unit 3)
DIP switch 2-3 = ON DIP switch 1-4 = ON DIP switch 5 = ON
1 2 3 4 5
ADR
ON
1 2 3 4 5
ON
ADR
1 2 3 4 5
ON
ADR